15
Since an Ethernet Adapter’s 10BaseT connector is wired to
operate like a standard Ethernet cabling hub, you must use a
10BaseT cross-over cable to connect an Ethernet Adapter to a
cabling hub. See Chapter 2 for information on the pinout speci-
fication for a 10BaseT cross-over cable.
Note that the Ethernet Adapter does NOT support roaming. A
wired network will support only one Ethernet Adapter acting as
a Master. A wireless client can not roam between two Ethernet
Adapters. However, an Ethernet Adapter, configured as a
Station, can roam between RangeLAN2 Access Points.
If your networking needs require greater wireless coverage than
what is provided by a single Ethernet Adapter, use multiple
RangeLAN2 Access Points in place of the Ethernet Adapter.
