Filter
Top Products
Trouble shooting
problem
Possible situation
No image
If choose the right signal mode
If open the input signal devices
If connect the signal cable
If connect the signal cable well
Under VGA mode ,setting the computer
frequency must over 75KHz?
Projector
turns off
automatically
25
Lamp
doesn t
work
When you turn off the projector ,
the lamp too hot, please wait at least
5 minute ,then you can turn it on again.
Input power are wrong ,please confirm
your projector power specification 220V or 110V
Lamp are broken or out of service life
please replace the lamp and test it again
Safety precautions
Warning;
when use this projector ,please read this manual carefully.
If wrong operation ,it will cause electric shock or fire.so when use
and repair this projector ,please comply with the following points
1,Read manual
Before use this projector ,please
read full manual carefully and
operate according to this manual instruction
2,Clear
when clear this projector ,please pull
out the power cable. Use the wet cloth
to clear,not the cleasner
3.Accessory
please use our recommended accessory.
Or it will damage the projector.
4,Use environment
Donot place the projector in wet environment
5,installation and fix
please place this projector in stable table .
6, Ventilation
the ventilation in the projector are best
for projector work stably. Donot let the dust
wall up the filter. Or it will cause the projector
high-temperature protected. So please use the
water to clear the filter per month.
7, Power
please make sure the power same as your
projector inquiry specification. (220 V or 110V)
8, Earthing wire
this projector has earthing wire .
It is three pin plug.
9,protect the power cable
Please confirm the power cable
are perfect when connect the
projector.
10,Thunder
when the thunder happen or long time
no use , please pull the power cable
out of projector.
11,Repairment
As the high voltage inside ,please
donot open or try to repair the
projector by yourself. . Please ask a
professional technician to repair
the projector.
12, Far away Heat device
please make sure this projector far
away other heat device . It will
damage the projector service life
2
Dust cover the filter
The filter long time no clean,
please clean it by water
The voltage is too low or big fluctuation