PYLE Audio PRJSD188 Projector User Manual


 
Trouble shooting
The projector operation is very simple . Just like to use TV.
please refer to this chapter when you encounter a problem
Problem
Possible situation
No power
Remote control
cannot open or
close the
projector
If open the power key
If there is no batteries in the remote control
If have obstruction between remote control
and projector
If have strong ray on the projector
This machine just turn off . You should
wait 5minutes and open the machine
again.
24
About the installation
In order to improve the projector service life,
It shouldnot place in a wet and
ventilation condition
Donot put the projector under the sunshine
directly
Projector working temperature: 0 +70
Projector store temperature : -20 +70
Fans will adjust the temperature It is controlled by system when the projector work,
the fans turn slowly or quickly so the fans noise are different But it is normal
when the projector work ,donot pull out the pwer cable If the fans stop to work,it will cause
the projector interior temperature very high, so it may damage the projector.
Warning
Caution
Donot block the ventilation-window
of projector
If the projector interior temperature
are too hot , the machine will be shut
off automatically.This is hot -
protected system.
So please clean the filter of projector
per month . It is very important.
Donot let the dust cover the filter.
About Open and close the projector
when open the projector ,connect
the power cable and press the "power"
key on the panel .the projector will
work ,but the lamp will be bright more
and more .After 5 minutes, the lamp work
normally
when close the projector , press the power
key again . And then the lamp shut off.
But the fans still work until 5minutes later.
When close the projector ,donot pull out
the power cable directly . After 5minutes,
the projector will shut off automatically.
3