Q-Logic 2310FL Network Card User Manual


 
2 – QLA2310F/2310FL
Label
2-6 FC2354603-00 A
Q
2.4
Label
The transceiver on the QLA2310F/2310FL HBA is a Class I laser product. It
complies with IEC 825-1 and FDA 21 CFR 1040.10 and 1040.11. The transceiver
must be operated under recommended operating conditions.
Fibre Channel
specifications
Bus type: Multimode fibre optic media
Bus transfer rate: 200 MBps maximum at half-duplex
400 MBps maximum at full-duplex
Interface chip: ISP2310
CPU Single-chip design that includes a QLogic RISC processor, Fibre
Channel protocol manager, PCI/PCI-X DMA controller, and
integrated serializer/deserializer (SERDES) and electrical
transceivers that can auto-negotiate a data rate of 1 Gbps or
2Gbps
RAM 256 KB of sync SRAM supporting parity protection
BIOS ROM 128 KB of flash ROM in two 64-KB, software selectable banks.
The flash is field programmable.
NVRAM 256 bytes, field programmable
Onboard DMA Five-channel DMA controller: two data, one command, one
auto-DMA request, and one auto-DMA response
Frame buffer FIFO Integrated 4-KB transmit and 6-KB receive frame buffer FIFO for
each data channel
Connectors LC-style connector that supports non-OFC, multimode fibre optic
cabling using a small form factor optical transceiver module
Form factor 17.78 cm×10.67 cm (7.0"×4.2") (QLA2310F)
16.93 cm×5.15 cm (6.7"×2.5") (QLA2310FL)
Operating power Less than 15 watts
Table 2-2. QLA2310F/2310FL Board Specifications (Continued)
Type Specification
CLASS I LASER PRODUCT