Filter
Top Products
59047-09 C 8-1
8 Firmware Download MIB
Objects
This section covers the implementation details for the Firmware Download
Management Information Bases (FD-MIB) on the SANbox switch.
Firmware Download MIB Definitions
The FD-MIB enables you to download, install, and activate new firmware on
QLogic SANbox switches using the Trivial File Transfer Protocol (TFTP). The
downloaded firmware can be activated using a hot reset (non-disruptive) or a hard
reset (disruptive).
A hot reset is a Non-Disruptive Code Load Activation (NDCLA) operation. The
firmware will be activated, the switch will be reset without a Power On Self Test,
and switch traffic will not be disrupted. The switch does not need to be rebooted
after the firmware is activated. During a hotreset operation, fabric services will be
unavailable for a short period (30-75 seconds depending on switch model). To
ensure that the NDCLA operation is successful, verify that all administrative
changes to the fabric (if any) are complete. When you need to do NDCLA/hotreset
to multiple switches, only perform the NDCLA/hotreset on one switch at a time,
and wait 75 seconds before performing the NDCLA/hotreset operation on the next
switch.
A hard reset is a Normal (or regular) reset operation. The firmware will be
activated, the switch will be reset with a Power On Self Test, and switch traffic will
be disrupted. The switch must be rebooted after the firmware is activated.
qlgcChFwOpResult (1.3.6.1.4.1.3873.3.1.1.2.1)
The status of the last firmware download and/or installation attempt.
Syntax
OBJECT IDENTIFIER
Access
read-only