Filter
Top Products
2. INSTALLATION
If the default address and interrupt settings are sufficient, the ES-100D can
be quickly installed and put to use. The factory defaults are listed in Figure 1.
3338 hexSerial 8
3330 hexSerial 7
3328 hexSerial 6
3320 hexSerial 5
3318 hexSerial 4
3310 hexSerial 3
3308 hexSerial 2
3300 hexSerial 1
IRQADDRESSPORT
Figure 1 --- Default address and IRQ settings for ES-100D
The output of the ES-100D is a 78-pin D-connector. A cable is provided
to convert the D-78 into eight standard male D-25 connectors with all control
signals provided to each port (RTS, DTR, CTS, DSR, DCD, and RI). See section
V of this manual for connector details.
1. If the default settings are correct, skip to step 2, otherwise refer to sections
III and IV of this document for detailed information on how to set the
address and IRQ level.
2. Turn off the power of the computer system in which the ES-100D is to be
installed.
3. Remove the system cover according to the instructions provided by the
computer manufacturer.
4. Install the ES-100D in any vacant expansion slot. The board should be
secured by installing the Option Retaining Bracket (ORB) screw.
5. Replace the system cover according to the instructions provided by the
computer manufacturer.
Attach and secure the cable connectors to the desired equipment.
2
Quatech ES-100D User's Manual