Filter
Top Products
CHAPTER 2: INSTALLATION 3
Chapter 2: Installation
Initial Configuration
Begin by connecting one computer, and once proper operation is confirmed, proceed to
connecting any additional computers.
Important: Make certain all computers are powered OFF before starting
installation.
1. Plug the monitor, keyboard, and PS/2 mouse into the ports marked VGA MONITOR, PS/2
or AT KEYBOARD, and PS/2 MOUSE on the CompuSwitch-PENT rear panel.
Figure 4 Rear Panel of CS-PENT 2 Unit
Figure 5 Rear Panel of CS-PENT 4 Unit
Figure 6 Rear Panel of CS-PENT 8 Unit
2. Using the appropriate CompuSwitch cable, connect one PC’s 25-pin connector to any channel
on the CompuSwitch rear panel.
3. Plug the cable’s video, keyboard, and mouse connectors into the computer ports.