Filter
Top Products
CC-SG 5.1.0 Release Notes Doc. #
255-80-0005-00 Page 2 of 9
Introduction
These Release Notes contain important information regarding a new release
of this product. Please read the entire document and the related
documentation available for this release.
Release 5.1.0 includes several enhancements and maintenance items. It also
establishes a common release for both the Hardware Appliance and Virtual
Appliance.
Release 5.1.0 documentation and upgrade firmware is available at
http://www.raritan
.com/support/commandcenter-secure-gateway/.
Applicability
Hardware Appliance
CC-SG 5.1.0 is applicable to CommandCenter ® Secure Gateway
hardware models CC-SG-V1 and CC-SG E1 only.
Important note for CC-G1 customers: Raritan discontinued the CC-G1
model in June of 2007. Do not attempt to upgrade your CC-G1 to this
release. Please back up your CC-G1, restore the database to a CC-SG V1
or E1 hardware unit running the same firmware version, and upgrade the
new V1 or E1 hardware unit to this release per the Upgrade Path
instructions below.
Virtual Appliance
CC-SG 5.1.0 is applicable to Virtual CommandCenter ® Secure Gateway.
Customers running release 5.0.5 may upgrade to version 5.1.0. Note that
release 5.0.5 was the introductory version of the virtual appliance and
does not run on the hardware models.
Upgrade Path
To upgrade a hardware appliance to this release you must be running
firmware version 5.0.0 (hardware appliance) or 5.0.5 (virtual appliance), as
depicted in the diagram below. There may also be additional upgrade steps to
take, depending on your current version. As indicated above, you can
upgrade CC-SG V1 or CC-SG E1 but not CC-G1 units to 5.1.0.