Filter
Top Products
8
q Connector Panel
u Filter
7 Air Inlet
w Speaker
e Lamp Cover
t Remote Sensor (Rear)
r Exhaust Vents
y Front Adjustable
Foot
i Rear Fixed
Foot
Blocked as it is not in used.
Opening it forcibly will cause
damage to the machine.
Bottom Surface
7 Air Inlet
Rear Side/ Right Side/Bottom Surface
Controls and Features
q Connector Panel
For details, refer to ‘Connector Panel’ . (☞ page 9)
w Speaker
Built-in speaker located here.
e Lamp Cover
Remove this cover when replacing the lamps. (☞ page 43)
r Exhaust Vents
Warm air is expelled through these vents to keep the sys-
tem cool. Please do not block the exhaust vents.
t Remote Sensor (Rear)
When operating with the remote control, aim it towards this
sensor. (☞ page 18)
*A remote sensor is also provided at the front of the projec-
tor.
y Front Adjustable Foot (for adjusting the height and
angle)
It is set at the lowest position when shipped from the fac-
tory. The foot can be adjusted to a maximum angle of +6º
and a maximum length of 31mm. (☞ page 15)
u Filter
Cleans air drawn in from the air inlet. Please clean the filter
regularly with eg, a vacuum cleaner. (☞ page 46)
i Rear Fixed Foot