Renesas M302N2T-PRB Network Card User Manual


 
( 24 / 38 )
3.5 Procedures for Making MCU File for M3T-PD30
It is necessary to change the contents of the MCU file according to the MCU to be developed. Make
the MCU file M302N1.MCU for M302N1 Group and M302N2.MCU for M302N2 Group and store
it in the following directory (the directory varies depending on the version of the M3T-PD30).
• M3T-PD30 Ver.5.00 or later: Store the MCU file in the "Mcufiles" folder in the directory same
as emulator debugger M3T-PD30 is stored.
• M3T-PD30 Ver.4.10 or earlier: Store the MCU file in the folder same as emulator debugger
M3T-PD30.
The contents of the MCU file (the SFR area, internal RAM area, internal ROM area, the name of
firmware file) are shown below. Change the settings according to the MCU to be debugged. Use your
text editor for changing the MCU file. The parts listed in boldface with an underline are to be changed.
The contents of the MCU file are as follows:
(1) For M302N2FCTGP (M302N2.MCU)
0: SFR area Start address
3FF : End address
400 : Internal RAM Start address
17FF : End address
E0000 : Internal ROM Start address
FFFFF : End address
M30620B : Name of firmware (Do not change.)
0: Expansion No. M3T-PD30 V.4.00 or later required (Do not change.)
(2) For M302N1M4T-xxxFP (M30217.MCU)
0: SFR area Start address
3FF : End address
400 : Internal RAM Start address
BFF : End address
E8000 : Internal ROM Start address
FFFFF : End address
M30620B : Name of firmware (Do not change.)
0: Expansion No. M3T-PD30 V.4.00 or later required (Do not change.)