Filter
Top Products
M30870T-EPB User’s Manual 2. Setup
REJ10J0482-0300 Rev.3.00 February 16, 2006
2.9.7 Connecting to a 100-pin 0.5-mm-pitch Foot Pattern (Part 3)
Figure 2.14 shows how to connect the emulation probe to a 100-pin 0.5-mm-pitch foot pattern on the user system with the
M3T-F160-100NSD (not included), and here following is its procedure. For details on the M3T-F160-100NSD, refer to its
user's manual.
(1) Mount the NQPACK100SD included with the M3T-F160-100NSD to the user system.
(2) Attach the YQPACK100SD included with the M3T-F160-100NSD to the NQPACK100SD.
(3) Insert the YQ-GUIDE's included with the YQPACK100SD to the YQPACK100SD.
(4) Attach the M3T-F160-100NSD to the YQPACK100SD.
(5) Attach the M30870T-EPB to the M3T-F160-100NSD.
Figure 2.14 Connecting to a 100-pin 0.5-mm-pitch foot pattern (3/3)
CAUTION
Notes on Connecting the User System:
Take care not to attach the converter board in a wrong direction. It may cause a fatal damage to the emulator.
The small connectors of the M30870T-EPB and M3T-F160-100NSD are guaranteed for only 50
insertion/removal iterations.
*
M3T-FLX160-EPB
M30870T-EPB
CN2 side
(5)
(1)
100 -pin 0.5-mm -pitch
(100P6Q) foot pattern
No. 1 pin
User system
M3T-F160-100NSD
(not included)
FLASH MCU etc.
On-board evalution
*: These four items are available in one package.
YQPACK100SD
NQPACK100SD
HQPACK100SD
(not included)
(2)
(3)
(4)
YQ-GUIDE (x4)
These corners are not round.
Page 36 of 104