Filter
Top Products
( 11 / 40 )
IMPORTANT
Notes on EMEM Dialog:
• When setting the EMEM dialog box of emulator debugger M3T-PD79, pay attention to the
following:
(1) Processor Mode
Specify a processor mode for the target MCU to be debugged. With 7906 Group MCUs, only
the single-chip mode is specifiable. If the MD0 pin setting is not "L" level, emulator debugger
M3T-PD79 outputs an error message. In such a case, check the pin settings on the target
system.
(2) Emem Address
Allocate the 1MB emulation memory that is included in the emulation pod. For the 7906
Group, it is not necessary to set this because this group operates only in the single-chip mode.
(3) ROM Address
Disable the allocated emulation memory against writes by the user program. For the 7906
Group, it is not necessary to set this because this group operates only in the single-chip mode.
(4) DMA Address
In this dialog box, set a transfer area when using the MCU's DMA function, and executing 1-
bus transfer between emulation memory and the target system. For the 7906 Group, do not set
such areas because this group does not have the DMA function.
(5) 8-bit bus mode Address
When accessing external data buses in 8-bit width using the chip select wait controller when
BYTE pin = Low, set this address for the relevant area. For the 7906 Group, it is not necessary
to set this because this group operates only in the single-chip mode.
(6) Map Address
Set external or internal for the allocated emulation memory area. For the 7906 Group, it is not
necessary to set this because this group operates only in the single-chip mode.
Note on Boot Mode:
• It is not possible to debug the MCUs in the boot mode using this emulator system.
(The MD1 pin of the MCU is fixed to the "L" level.)
Note on Breaks Used with Internal Resources:
•H/W breaks cannot be used with internal resources (SFR, internal RAM and internal flash ROM)
when using emulator PC4701L.
Note on Debug Monitor Area:
• The debug monitor area is fixed to the "FF" bank. It cannot be set to other banks.