Renesas M61323SP/FP Switch User Manual


 
M61323SP/FP
REJ03F0201-0201 Rev.2.01 Mar 31, 2008
Page 18 of 19
Cautions for Manufacturing Boards
Built-in wide band preamplifier may cause oscillation due to the wiring shape on the board.
Be careful for the following points.
V
CC
shall use a stable power supply.
(Individual V
CC
should use an independent power supply.)
GND should be as wide as possible. Basically, solid earth should be used.
Make the load capacitance of output pins as small as possible.
Also ground the hold capacitance to stable GND, which is as near to the pin as possible.
Insertion of a resistance of several tens of ohms between the output pin and the circuit at the next stage makes
oscillation harder.
When inserting an output pull-down resistance, make wire between the output pin and the resistance as short as
possible.