Filter
Top Products
38
Detailed description
[Screen size]
Normal• : Enlarge an input image to fit the screen without changing the aspect
ratio of video signals.
Full• : Displays an input image in 1024 × 768 dot resolution by enlarging it to
fill the entire screen. (X3131/X3241)
Displays an input image in 1280 x 800 dot resolution by enlarging it to
fill the entire screen. (WX3131)
Thru• :
Displays an input image in the native resolution of the video signals. Thru
display is not available for Y/PB/PR, Video and S-Video-input images.
The larger image than the screen size will be displayed over the
screen. The input image may appear vertically long with some
frequencies of video signals.
Wide
(X3131/
X3241)
• : Displays an input image in the center of the screen with a 16:9 aspect
ratio by enlarging it to fit the width of the screen. The upper and lower
portions of the image will be compressed.
Wide display is not available for Computer-input images.
4:3 zoom
(WX3131)
• : Displays an input image with a 4:3 aspect ratio by enlarging it
vertically. The enlarged image will be displayed over the screen.
4:3 zoom display is not available for computer images.
For Y/PB/PR input, screen size setting function is not available for the video signals
with a 16:9 aspect ratio.
•
Note
If you use the screen size setting function on commercial video software, broadcast
or cable-broadcasting programs to display images with the varying aspect ratio
except for the purpose of your private viewing and listening, it may infringe the
copyright protected by the copyright laws.
[Up/down shift]
Shifts the projected image vertically when [Screen size] is [Wide] for X3131/X3241.
Shifts the projected image vertically when [Screen size] is [4:3 zoom] for WX3131.
[Blackboard mode]
Projects the image in colors more like projecting on a screen.
Precaution
The projected image may differ depending on the type, color, and material of the
blackboard and wall even if the selected color is the same as the projected screens.
[Background]
RICOH is set for [Logo] by factory setting.
If user’s logo has been registered, it is displayed when [Logo] is set for background.
[Start-up screen]
If user’s logo has been registered and this setting is [On], the logo is displayed at start-up.
[User logo]
Registers a part of the image that is input from computer, as a stationary picture and
displays it as a logo at start-up and when no signal is input.
•
•
•
•
Using the menus (Continued)