Filter
Top Products
MAINTENANCE
1. Thermal Head Cleaning
Clean the thermal head when 2 master rolls have been used.
I
I
I
1. Turn off the main switch.
2. Open the original table. (See page
38.)
3. Move the pressure release lever in the
direction of the arrow. (See page 38.)
4. Loosen the screw knobs located on
both sides of the feed roller.
5. Grip both ends of the feed roller and
lift it straight up.
6. Clean the thermal head as follows.
I) Wipethe surfaceof the thermal headwith
a damp cloth.
2) Cleanthe surfaceof thermal head several
times usingthe cleaner
pen with cleaning
solution. (The cleaner pen is stored in the
carton box as an accessory.)
3) Dry the surface of thermal head with a
clean dry cloth.
I
Warning: Make sure to replace the cap of
cleaner after using it.
. Replace the felt of the cleaner pen if it be-
comes ditty.
7. Install the feed roller
above procedure.
. Make sure to tighten
both sides
of the feed
by reversing the
the screw knobs on
roller.
40