Filter
Top Products
Rimage 360i
12 110808_C
# Tip If you print on areas
of the disc where the
surface is not suitable
for printing, the ink can
smear or run.
Changing or enabling masking
This functionality allows you to adjust the non-printable area, or mask,
settings for standard CD/DVD 120 mm media.
1.
Navigate to Printing Preferences (refer to page 9).
2. Select the Mask Settings tab.
3. To enable mask settings, select the Enable Masking checkbox.
4. Change the mask settings as desired.
5.
When you have made the desired choices, select OK. The Disc
Color 360i Properties window closes.
Note: Select the Default button to return mask settings to the
factory settings.
# Tip: The image below
shows a disc with a
stacking ring.
# as
ink will
#
areas:
S
eter 38 mm
H
Inner Diameter 24 mm
Tip: If you print on are
of the disc where the
surface is not suitable
for printing, the
smear or run.
Tip: Most discs with a
printable hub and a
stacking ring have the
following printable
tandard Area
Outer Diameter 118 mm
Inner Diam
ub Area
Outer Diameter 35 mm
Printing on hub with a stacking ring
This functionality allows you to print on the hub area of the disc. If your
discs have a printable hub area, and there is a gap for the stacking
ring, use this procedure.
1.
Navigate to Printing Preferences (refer to page 9).
2. Change mask settings.
a. Select the Mask Settings tab.
b. Select the Enable Masking checkbox.
c. In the Hub Area Settings box, select the Printing on Hub
checkbox.
3. Measure the printable area and adjust the settings.
a. Measure the inner diameter of the printable surface.
b. In the Hub Area Settings, enter the inner diameter that you
measured in step a.
c. Measure the outer diameter of the printable hub area.
d. In the Hub Area Settings, enter the outer diameter that you
measured in step c.
e. Measure the inner diameter of the standard printable area.
f. In the Standard Area Settings, enter the diameter that you
measured in step e.
4. After you have entered the correct measurements,
select OK. The
Disc Color 360i Properties window closes.