Filter
Top Products
Chapter 4 Using the command line interface
22 Using the Smart Ringswitch Gigabit Module
Setting the Gigabit port IPX address
The
set gigabit port IPX address
command specifies the IPX network number for the port. If this is zero then
the IPX network number is learned automatically by the Gigabit port.
Setting the Gigabit port IP mode
The
set gigabit port IP mode
command enables or disables the translational bridging of IP frames.
Command:
>set Gigabit port IPX address <slot>:<port> <number>
Parameter:
slot
Slot number
port
Port number
number
IPX network number
Command:
>set Gigabit port IP mode <slot>:<port> <1,2>
Parameter:
slot
Slot number
port
Port number
1
Enable
2
Disable
Gigdoc.book Page 22 Tuesday, October 17, 2000 9:44 AM