Filter
Top Products
203
Installing the Wave Expansion Board
Installing the Wave Expansion Board
Up to three optional Wave Expansion Boards (one SR-JV80 series,
two SRX series) can be installed in the Fantom.
Wave Expansion Boards store Wave data, patches, and rhythm sets,
and by equipping the Fantom-S/Fantom-S88 with these boards, you
can greatly expand your sound palette.
Cautions When Installing an
Wave Expansion Board
●
To avoid the risk of damage to internal components that can be
caused by static electricity, please carefully observe the following
whenever you handle the board.
• Before you touch the board, always first grasp a metal object
(such as a water pipe), so you are sure that any static electricity
you might have been carrying has been discharged.
• When handling the board, grasp it only by its edges. Avoid
touching any of the electronic components or connectors.
• Save the bag in which the board was originally shipped, and put
the board back into it whenever you need to store or transport it.
●
Use a Philips screwdriver that is suitable for the size of the screw
(a number 2 screwdriver, Fantom-s only). If an unsuitable
screwdriver is used, the head of the screw may be stripped.
●
To remove a screw, rotate the screwdriver counter-clockwise. To
tighten the screws, rotate the screwdriver clockwise.
fig.18-01.e
●
When installing Wave Expansion Boards, remove only the
specified screws.
●
Be careful that the screws you remove do not drop into the interior
of the Fantom-S/S88.
●
Do not leave the bottom cover removed. After installation of the
Wave Expansion Boards is complete, be sure to replace the cover.
●
Be careful not to cut your hand on the opening for installing the
board.
●
Do not touch any of the printed circuit pathways or connection
terminals.
●
Never use excessive force when installing a circuit board. If it
doesn’t fit proper(•)To5.4