Filter
Top Products
Wireless Adapter RNX-G300EX/LX User Manual
- 73 -
A. A successful PBC Configuration :
Start PBC connection ~> Scanning AP ~> Begin associating to WPS AP ~> Associated to
WPS AP ~> Sending EAPOL-Start ~> Sending EAP-Rsp (ID) ~> Receive EAP-Rsp (Start)
~> Sending M1 ~> Received M2 ~> Sending M3 ~> Received M4 ~> Sending M5 ~> Received M6 ~> Sending M7 ~>
Received M8 ~> Sending EAP-Rsp (Done) ~> Configured
~> WPS status is disconnected ~> WPS status is connected successfully-SSID
B. No PBC AP available :
Scanning AP ~> No PBC AP available ~> Scanning AP ~> No PBC AP available ~>...
C. Too Many PBC AP available :
Scanning AP ~> Too Many PBC AP available ~> Scanning AP ~> Too Many PBC AP
available ~>...
D. WPS configuration doesn't complete after two-minute connection : WPS Eap process failed.
E. When Errors occur within two-minute connection, the WPS status bar might report on" WPS Eap process failed".
Error messages might be :
1. Receive EAP with wrong NONCE.
2. Receive EAP without integrity.
3. An inappropriate EAP-FAIL received.
Describe "Multiple PBC session overlaps" as follow :
A. Dual bands :
AP1 is a G-Band AP using PBC mode. (ID = 0x0004) AP2 is a A-Band AP using PBC mode. (ID = 0x0004) They have the
same UUID-E.
STA would regard these two APs as a dual-radio AP and select one band to connect.
B. Different UUID-E :
AP1 is a G-Band AP using PBC mode. (ID = 0x0004) AP2 is a G-Band AP using PBC mode. (ID = 0x0004) They have the
different UUID-E.
STA would regard these two APs as two different APs and wait until only one PBC AP is available.