Filter
Top Products
2. RuggedBackbone™ Modules
RuggedCom® RuggedBackbone™ 11 RX1510 Installation Guide Rev 104
2. RuggedBackbone™ Modules
The RX1510 chassis provides six module slots . Each slot accommodates a particular type of
RuggedCom module. Figure 2.1, “RX1510 Chassis Slot Assignment” shows the module slots on
the RX1510.
Figure 2.1. RX1510 Chassis Slot Assignment
The RX1510 chassis supports the following modules:
LM1 through LM4
The RX1510 chassis supports up to four line module (LM) cards. For more information on line
modules, see Section 2.2, “Line Modules (LM)”.
All modules are built to the RuggedRated™ specifications of the RuggedBackbone™ RX1510.
Each module type is described in the following sections.
To install a module into the RuggedBackbone™ chassis, align the module guide ribs
with the channels on the chassis. Push the module in as far as it will go, being sure to
push through the resistance provided by the grounding springs. When properly seated,
the module flange will rest on the main chassis frame. Tighten the thumbscrews using
finger strength only.