27
Runco CL-610 Owner’s Operating Manual
Turning on the Power
Basic Operation
LIGHT
OFFON
VID S-VID COMP1
RGBHD HDMI
COMP2
Focus
Zoom out
Zoom in
• Adjust the projected image size with
the zoom ring on the lens. To focus the
image, rotate the focus ring on the
lens.
Adjusting the Zoom and
Focus
• Turn on the main power switch. The
POWER LED will light orange.
• Press the ON button on the remote
control to turn on the projector. The
POWER LED flashes orange during
the warm up period, then lights solid
green.
• “Searching….” appears on the
screen before the projector identifies
the input signal, and remains there
until a valid signal is detected.
• If an incompatible input signal exceeds
the range of the projector a “No signal
supported” message will be displayed
on the screen. This message remains
on the screen until you change the
input signal.
• To adjust the projector height or
projection angle, or to compensate for
a mounting surface that isn’t level, turn
the four adjustable feet on the bottom
of the projector.
Adjusting Projector
Height or Projection
Angle