Filter
Top Products
Installation
26 Runco PlasmaWall Owner’s Operating Manual
PRE
L
IMINAR
Y
RS-232 Controller
Connection
Use a standard, 9-pin RS-232 cable to connect a PC or home theater control/automation
system (if present) to the RS-232 Control port on the DHD Controller; see
Figure 3-9.
For more information about using this connection, refer to Serial Communications on
page 49.
Figure 3-9. RS-232 Control System Connection
Connecting 12-Volt
Trigger Outputs to
External
Theater
Components
If your home theater contains equipment that responds to 12-volt triggers, connect them
to the 12-volt trigger outputs as shown in
Figure 3-10.
Figure 3-10. Connecting 12-Volt Trigger Outputs
➤
Pb Pr Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
1
2
TRIGGERS
RS-232 OutComponent Video
1
2
345
7
89
6
to Automation/
Control System
or PC
2 Transmit Data
3 Receive Data
5 Ground
(none of the other pins are used)
➤
Pb Pr Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
1
2
TRIGGERS
RS-232 OutComponent Video
to 12-Volt
trigger-activated
equipment
3.5-mm
mini plug