Filter
Top Products
21
The Installation menu is where you can adjust the Picture Orientation, Keystone, Lamp Output, and
even check the age of the lamp in the Projector.
When the Controller is turned on for the first time, the INSTALLATION item will not appear in the
main menu. To enable the INSTALLATION menu, there are two options:
1) With the processor ON and no menus on-screen, simultaneously press the ENTER, UP and LEFT
buttons (you do not need to hold them down). Release the three buttons and press MENU, ensure
INSTALLATION is now on the bottom of the main menu.
2) With the remote control, press button 6 (with no menus on-screen). After pressing '6', press MENU
and ensure INSTALLATION is now on the bottom of the main menu.
After INSTALLATION has been accessed, press MENU, highlight
INSTALLATION and press ENTER. This will bring up the INSTALLATION
MENU, shown on the right:
Installation Menu
INSTALLATION
Lamp Mode
Keystone
Picture Orientation
IR Code Set
Lamp Hours 20
Installation Menu
Lamp Mode
The Lamp Mode enables the installer to set the lamp for full brightness (normal) or Low (20% lower).
If a small screen is being used in a dark area or the image is otherwise too bright, it may be a good
idea to set the Lamp Mode to LOW. When the Lamp Mode is set to LOW, the lamp will last longer as
a result of the lower current setting.
Keystone
KEYSTONE: Corrects the trapezoidal distortion that results from projecting at an angle:
A correctly adjusted image
An image with Keystone error
This may occur in installations where the projector needed to be angled as a result of a larger vertical
offset. This keystone feature will correct for trapezoidal distortion for as much as a 15° projector angle.
Picture Orientation
This will set the orientation of the image for your installation. If the Projector will be mounted on a
table, set this for Floor. If mounting it on the ceiling, select Ceiling. For two-mirror or ‘straight-shot’
rear-screen applications, select floor rear or ceiling rear as appropriate.