Filter
Top Products
Maximum Pixel Clock
360 MHz
Power Supply
90 ~ 264VAC rms, 60/50 Hz ± 3 Hz
Power Consumption
130 W (nominal)
Dimensions (WxDxH)
504 x 500 x 508 mm / 19.8 x 19.7 x 20 inch (After installation of Stand)
Weight
28.0 kg
Environmental considerations
Operating Temperature 32°F ~ 104°F(0°C ~ 40°C)
Humidity 10% ~ 80%, non-condensing
Storage Temperature -4°F ~ 113°F (-20°C ~ 45°C)
Humidity 5% ~ 95%, non-condensing
Plug and Play Capability
This monitor can be installed on any Plug & Play compatible system. Interaction of the monitor and
computer systems will provide the best operating conditions and monitor settings. In most cases,
monitor installation will proceed automatically, unless the user wishes to select alternate settings.
Note : Design and specifications are subject to change without prior notice.
PowerSaver
This monitor has a built-in power management system called PowerSaver. This system saves energy by
switching your monitor into a low-power mode when it has not been used for a certain amount of time.
The monitor automatically returns to normal operation when you press a key on the keyboard. For energy
conservation, turn your monitor OFF when it is not needed, or when leaving it unattended for long periods.
The PowerSaver system operates with a VESA DPMS compliant video card installed in your computer.
Use a software utility installed on your computer to set up this feature.
State Normal Operation
Power-off mode
EPA/ENERGY 2000
Power Indicator Green Green, Blinking
Power Consumption 130 W (nominal) Less than 2 W
Preset Timing Modes
If the signal transferred from the computer is the same as the following Preset Timing Modes, the
screen will be adjusted automatically. However, if the signal differs, the screen may go blank while
the power LED is on. Refer to the video card manual and adjust the screen as follows.