Filter
Top Products
User’s Manual 3-33
Installing a memory module
To install a memory module, follow the steps as detailed below:
1. Shut down the computer - make sure the Power indicator is off (refer to
the Turning off the power section in Chapter 1, Getting Started if
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel.
4. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack section in Chapter 5, Power and Power-Up
Modes, if required).
5. Loosen the screw securing the memory module cover in place - please
note that the screw is attached to the cover in order to prevent them
from being lost.
6. Slide your fingernail or a thin object under the cover and lift it off.
Figure 3-9 Removing the memory module cover (Satellite
L770/L775/L770D/L775D/satellite Pro L770/L775/L770D/L775D)
7. Align the notch of the memory module with that of the memory slot and
gently insert the module into the slot at about a 30 degree angle before
holding it down until the latches on either side snap into place.
Use a point size 1 Phillips screwdriver.
1. Screw 2. Memory module cover
1
2