Filter
Top Products
A
PPENDIX
A.11
A
N
OTES
:
• Do not use letterhead paper printed with low-temperature inks, such as those used in
certain types of thermography.
• Do not use raised or embossed letterhead.
• The machine uses heat and pressure to fuse toner to the paper. Insure that any
colored paper or preprinted forms use inks that are compatible with this fusing
temperature (200 °C or 392 °F for 0.1 second).
Paper Specifications
Paper Output Capacity
Jamming, damage to
machine
Cutouts or perforations Do not use paper with cutouts or
perforations.
Problems with feeding Ragged edges Use good quality paper.
Category Specifications
Acid Content 5.5 pH or lower
Caliper 0.094 ~ 0.18 mm (3.0 ~ 7.0 mils)
Curl in Ream Flat within 5 mm (0.02 in.)
Cut Edge Conditions Cut with sharp blades with no visible fray.
Fusing Compatibility Must not scorch, melt, offset or release hazardous
emissions when heated to 200 °C (392 °F) for 0.1
second.
Grain Long Grain
Moisture Content 4 % ~ 6 % by weight
Smoothness 100 ~ 400 Sheffied
Symptom Problem with Paper Solution
Output Location Capacity
Face-down output tray
150 sheets of 75 g/m
2
bond (20 lb) paper
Face-up output slot
1 sheet of 75 g/m
2
bond (20 lb) paper