Filter
Top Products
English English ItalianoFrançais Español Deutsch Português
5
Chapter Two: Installation
Connecting Your Monitor
to a Computer
1
Turn off your computer and unplug
its power cord.
2
Connect the signal cable to the
D-SUB or BNC signal port on the
back of your monitor.
3
If you are using an IBM-compatible
computer, skip to step 5. If you are
using a Macintosh computer,
connect the other end of the signal
cable to a Macintosh adapter.
4
Follow the instructions included
with your adapter to set the pins on
your adapter, if necessary.
5
Connect the signal cable (With the
adapter, if necessary) to the video
port on the back of your computer.
This port might be directly attached
to your computer, or it might be
part of a video adapter, video card,
or graphics card.
6
Connect the power cord for your
monitor to the power port on the
back of the monitor.
7
Plug the power cords of your
computer and your monitor into a
nearby outlet.
8
Turn on your computer and monitor.
If your monitor displays an image,
installation is complete.
R
G
B
2
6
7
3
5
SE-900IFT-E 4/29/92 5:23 PM Page 5