Filter
Top Products
Using 3-5
3-5-3. Setup
MENU DESCRIPTION
Install To tailor the picture to the installation location, you can invert the projected images vertically / hori-
zontally.
• <Front-Floor> : Normal Image
• <Front-Ceiling> : Horizontal/Vertical Reversed Image
• <Rear-Floor> : Horizontally Reversed Image
• <Rear-Ceiling> : Vertically Reversed Image
Lamp Mode Used to set the image brightness by adjusting the amount of light generated by the lamp.
• <Eco> : This mode is optimized for screens smaller than 100 inches.
This mode decreases the lamp brightness and power consumption in order to extend the lamp
lifetime and reduce noise and power consumption.
• <Normal> :This mode is te most general mode and works well in most situations.
• <Bright> : This mode maximizes the lamp brightness when the ambient illumination is bright. As
the brightness of the lamp increases, the lamp lifetime can be reduced and noise and power
consumption may increase.
Auto Keystone If video scenes are distorted or tilted, you can compensate for this by setting the <Auto Keystone>
function to <On> so that the <V-Keystone> function automatically starts.
• <Off>-<On>
Keystone If video scenes are distorted or tilted, you can compensate for this using the vertical/horizontal Key-
stone function.
• <V-Keystone > : When the projector image is not displayed vertically on the screen, the image
can be calibrated using the <V-Keystone> function.
• <H-Keystone> :When the projector image is not displayed horizontally on the screen, the image
can be calibrated using the <H-Keystone> function.
The <Keystone>, which is a function for calibrating a skewed image, may degrade image
quality when it is activated.
The sound output of your projector is temporarily stopped while the keystone is being changed.
The <Keystone> function does not adjust the appearance of the On Screen Display (OSD).
Background You can set the <Background> the projector displays when there is no signal from the external device
connected to the projector.When the projector receives a signal, the <Background> you set disap-
pears and the projector displays a normal screen.
• <Logo>-<Blue>-<Black>
Test Pattern Generated by the projector itself. Use to optimize the installation of the projector.
• <Crosshatch> : You can check whether the picture is distorted or not.
• <Screen Size> : You can refer to picture format sizes such as 1.33 : 1 or 1.78 : 1.