Filter
Top Products
ٻ
ڌڋٻ
6. Setting The Dip Switches
6-1. Setting the Dip Switches
The Dip Switches are located on the bottom of the printer. The Dip Switches are used to
set the Printer to perform various functions. Follow these steps when changing Dip
Switches setting :
1. Turn the printer power switch off.
2. Remove the screw on the bottom
of the printer and open the bracket.
3. Flip the Dip Switches using tweezers
or another narrow-ended tool.
Switches are off when up and on
when down in the Figure below.
4. The new setting takes effect
when you turn on the printer.
Note : Always change Dip Switch settings
only when the printer is turned off.
6-2. Functions of Dip Switches
6-2-1. Dip S/W 1 6-2-2. Dip S/W 2
No Functions
Details
1 Speed
Off 4.0 ips
1
Speed
Selection
On 5.0 ips
4 3 2 Density
Off Off Off 13
Off Off On 14
Off On Off 15
Off On On 16
On Off Off 17
On Off On 18
On On Off 19
2
3
4
Density
Selection
On On On 20
Off Normal mode
5
Exhibition
Selection
On Demo mode
Off Label Paper
6
Media
Selection
On
Thermal Continuous Paper
Off Without Auto Cuter
7 Auto Cutter
On With Auto Cutter
Off Enable
8
Near End
Sensor
Status
On Disable
No Functions Details
2 1 Baud Rate
Off Off 9,600 bps
Off On 19,200 bps
On Off 57,600 bps
1,2
Baud
Rate
On On 115,200 bps
Off Detect Gap
3
Media
Detection
On Detect Black-mark
4 Reserved --
Off SAMSUNG command
5 Emulation
On Emulation
Off Receive Buffer Full
6
Busy
Condition
On
*Offline
*Receive Buffer Full
7 Reserved --
Off Disable
8
Long label
Split printing
On Enable
ٻ
ٻ
ڌڌ
7
. The Self Test
The self-test checks whether the printer has any problems. (You cannot perform this
procedure if using the printer’s label peel-off option) If the printer does not function
properly, contact your dealer. The self-test checks the following;
1. Make sure that paper roll has been installed properly.
2. Turn on the power while holding(2sec) down the FEED button. The self-test begins.
3. The self-test prints the current printer status, which provides the control ROM version
and the DIP switch setting.