Filter
Top Products
Windows ME/2000 :
Set the resolution at the Control Panel
→
Display
→
Settings.
Contact the video card manufacturer for details.
How can I set the Power
Saving function?
Windows XP :
Set the resolution at the Control Panel
→
Appearance and Themes
→
Display
→
Screen Saver.
Set the function at BIOS-SETUP of the computer.
Windows ME/2000 :
Set the resolution at the Control Panel
→
Display
→
Screen Saver.
Set the function at BIOS-SETUP of the computer.
Refer to Windows/Com
p
uter Manual
How can I clean the outer
case/LCD Panel?
Disconnect the power cord and then clean the monitor with a soft cloth,
using either a cleaning solution or plain water.
Do not leave any remains of the detergent nor scratch the case. Do not
allow any water to go inside the monitor.
How can I completely
remove the “UC Monitor
Installation Program”?
To completely remove the USB Device installation program for the UC
monitor, Click ‘Add/Remove Programs’ in the ‘Control Panel’ and a list
of currently installed programs is displayed.
Select the driver (USB video device and USB audio device) installed
when your UC monitor was connected from the list and click on
‘Remove’.
Self-Test
Self-Test Feature Check | Warning Messages | Environment | Useful Tips
Your monitor provides a self test feature that allows you to check whether your monitor is functioning
properly.
Sel
f
-Test Feature Check
Turn off both your computer and the monitor.
Unplug the video cable from the back of the computer.
Turn on the monitor.
If the monitor is functioning properly, you will see a box in the illustration below.
This box appears during normal operation if the video cable becomes disconnected or damaged.
Turn off your monitor and reconnect the video cable; then turn on both your computer and the
monitor.
If your monitor screen remains blank after using the previous procedure, check your video controller
and computer system; your monitor is functioning properly.
Warnin
g
Messa
g
es