Sanyo PLV-Z1 Projector User Manual


 
35
Computer Input
Computer Adjustment (Manual)
This projector can automatically tune to the display signals from most personal computers currently distributed. However,
some computers employ special signal formats which are different from the standard ones and may not be tuned by Multi-
Scan system of this projector. If this happens, the projector cannot reproduce a proper image and the image may be
recognized as a flickering picture, a non-synchronized picture, a non-centered picture, or a skewed picture.
This projector has a manual computer adjustment to enable you to precisely adjust several parameters to match with those
special signal formats. This projector has 5 independent memory areas to memorize those parameters manually adjusted.
This enables you to recall the setting for a specific computer whenever you use it.
Computer Adjustment menu
Press POINT
LEFT/RIGHT button
to adjust the value.
Press the MENU button, and the main menu appears. Select
the Computer Adjustment menu with the POINT UP/DOWN
button, and then press the POINT RIGHT button to enter the
sub-menu.
1
2
Choose the item that you want to adjust, and then press the
POINT LEFT/RIGHT button to adjust the value. The Fine sync
and Total dots are displayed in a line. Press the SELECT button
after adjusting them. The on-screen menu returns to the sub-
menu.
Computer Adjustment menu
Selected Mode
Shows status
(Stored/Free) of the
selected mode.
To store the adjustment parameters, select the Store with the
POINT UP/DOWN button and press the POINT RIGHT button.
Press the
SELECT button
at this icon to
display other
items.
Press the SELECT button at this
icon to close the item.
3
Reset
To reset to previous level, select the Reset with the POINT
UP/DOWN button and press the POINT RIGHT button. Select
"Yes" with the SELECT button.