14
CONNECTING THE PROJECTOR
These jacks will contain the audio information of the selected program source being viewed on the screen (Computer 1,
Computer 2, Video 1 or Video 2). If you have selected program source Computer 2 the audio signal connected to the
Computer 2 audio input jack will be available at the audio monitor output jacks.
Use RCA type audio for connection.
● If the audio input of the audio equipment is stereo, be sure to connect the right and left channels to the respective right
and left jacks.
● If the audio input of the audio equipment is monaural, connect it to the left jack.
Vcc
- Data
+ Data
Ground
1
2
3
4
54321
109876
15 14 13 12 11
2
34
1
12345
6789
This terminal output the information of the selected computer source being viewed on the screen (Computer 1 or Computer 2).
When video source ("Video 1" or "Video 2") is selected, this terminal outputs Computer 1 input information.
An external monitor can be connected to the HDB15-pin (VGA) terminal on the projector.
● Connect the monitor to this terminal using the VGA cable (not provided).
––––––––
R x D
T x D
––––––––
Ground
––––––––
––––––––
––––––––
––––––––
1
2
3
4
5
6
7
8
9
■ SERIAL PORT
DB9-PIN
TERMINAL
■ USB PORT
Pin No./Signal
1 Red input
2 Green input
3 Blue input
4 Sense 2
5 Ground (Horiz.sync.)
6 Ground (Red)
7 Ground (Green)
8 Ground (Blue)
Pin No./Signal
9 Non Connect
10 Ground (Vert. sync.)
11 Sense 0
12 Sense 1
13 Horiz. sync
14 Vert. sync
15 Reserved
HDB 15-PIN
TERMINAL
CONNECTING TO THE MONITOR OUTPUT TERMINAL (ANALOG HDB 15-PIN)
CONNECTING TO THE AUDIO MONITOR OUTPUT (VARIABLE) JACKS
CONNECTING TO THE SERIAL PORT (DB 9-PIN) TERMINAL
CONNECTING TO THE USB PORT CONNECTORS (1 and 2)
● If you control the projector by computer, you must connect a cable
(not provided) from your computer to this terminal.
This port is used to control the projector with the computer. It is also
used to control the computer with the Remote control of this projector.
(Refer to P49, 50.)
Connect the USB port of the computer to this port.