Sanyo PLC-EF12NL Projector User Manual


 
8
PREPARATION
SETTING-UP THE PROJECTOR
This projector uses nominal input voltages of 100-120 V or 200-240 V
AC. The projector automatically selects the correct input voltage. It is
designed to work with single-phase power systems having a grounded
neutral conductor. To reduce the risk of electrical shock, do not plug
into any other type of power system.
Consult your authorized dealer or service station if you are not sure of
the type of power supply being in use.
Connect the projector with the peripheral equipment before turning the
projector on. (Refer to pages 13 ~ 22 for connection.)
CONNECTING THE AC POWER CORD
Connect the AC Power Cord (supplied)
to the projector.
The AC outlet must be near this
equipment and must be easily
accessible.
To the POWER CORD
CONNECTOR on the
projector.
Projector side AC Outlet side
Ground
NOTE ON THE POWER CORD
The AC Power Cord must meet the requirement of the country where you use the projector.
Confirm the AC plug type with the chart below and the proper AC power cord must be used.
If the supplied AC Power Cord does not match the AC outlet, contact your sales dealer.
To the AC Outlet.
(120 V AC)
For Continental Europe
For the U.S.A. and Canada
For the U.K.
To the AC Outlet.
(200 - 240 V AC)
To the AC Outlet.
(200 - 240 V AC)