Sanyo PLC-XP51 Projector User Manual


 
13
CONNECTING PROJECTOR
SVIDEO
RAUDIOL
VIDEO/Y Cb/Pb Cr/Pr
VIDEO/Y Cb/Pb Cr/Pr
RESET
CONTROL PORT
USB
AUDIO 1
AUDIO 2
ANALOG IN/OUT
DIGITAL(DVI-D)
INPUT 1
INPUT 2
INPUT 3
R/C JACK
G B R H/V V
(
MONO
)
IN/OUT
ON
1
DIP
ON
OFF
23456
13" MODE (640 x 480)
16" MODE (832 x 624)
19" MODE (1024 x 768)
OFFON ON
ON ON
ON ON
OFF OFF OFF
OFFOFF OFF OFF
OFF OFF OFF OFF
123456
OFF OFFON ONON ON21" MODE (1152 x 870)
CONNECTING TO COMPUTER
IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA)
VGA Cable
Monitor Output
Desktop type Laptop type
Control Cable
for Serial Port
Terminal
Serial port
PS/2 port
Audio Output
CONTROL
PORT
COMPUTER
AUDIO IN 1 or 2
COMPUTER IN ANALOG
Use one of these Control
Cables corresponding with
terminal of your computer.
ADB port
Cables used for connection ( = Cable or adapter is not supplied with this projector.)
Control Cable
for PS/2 Port
Control Cable
for ADB Port
Audio
Cable
(stereo)
NOTE :
When connecting cable, power cords
of both a projector and external
equipment should be disconnected
from AC outlet. Turn a projector and
peripheral equipment on before
computer is switched on.
USB port
MAC Adapter
Set slide switches
according to chart
below.
VGA Cable (HDB 15 pin)
DVI-Digital Cable (for Single Link T.M.D.S.)
BNC Cable
Control Cable for Serial Port
Control Cable for PS2 Port , or ADB Port
USB Cable
MAC Adapter (When connecting to Macintosh computer)
Audio Cables (Mini Plug (stereo) x 2)
Terminals
of a Projector
Terminal
Terminal
DVI
Cable
Monitor Output
USB
COMPUTER IN DIGITAL
Set switches as shown in table
below depending on RESOLU-
TION MODE that you want to
use before you turn on projec-
tor and computer.
MAC ADAPTER
USB
Cable
BNC
Cable
Audio Speaker
(stereo)
Audio Amplifier
Audio Cable
(stereo)
Audio Input
AUDIO OUT
External Audio Equipment
Monitor Output
or
Monitor Input
NOTE;
This terminal is switchable.
Set the terminal up as
either Computer input or
Monitor output before
using this terminal.
(See page 23.)
NOTE;
This terminal is switchable.
Set the terminal up as either
Computer audio input 1 or audio
monitor output (variable) before using
this terminal. (See page 23.)