Filter
Top Products
ROTATED FIELDS
The CT Series printers can rotate each print field in 90° increments using the
<ESC>% Rotate command.
The following data stream will rotate the print field but will not change the base
reference point of the field:
<ESC>A
<ESC>%1<ESC>V800<ESC>H200<ESC>L0202<ESC>XB1E<ESC>Q1<ESC>Z
COMMAND DEFAULT SETTINGS
There are some types of commands that must have a value specified before a label
can be printed. If the data stream does not contain these commands, a “default” value
is assumed. The default settings are determined by the values specified in the last
<ESC>PG Printer Setting command sent to the printer. These values are stored in
EEPROM and will remain valid even if power to the printer is cycled.
COMMAND CODES
This section contains all the CT Series printer Command Codes. The commands must
be sent to the printer in an organized fashion in order for the label(s) to print.
The purpose of this section is to:
1. Explain the different commands and provide examples of their usage.
2. To provide a detailed reference for programming the CT Series Printers.
Each command begins on a separate page with its own heading. A uniform layout is
used to help you find key information about each command. For each Command
E
H=200
V=800
Base
Ref
Point
Label
Feed
Direction
“%1”
Section 4. Programming Reference
Page 4-69001069A SATOCTSeriesPrinters