Filter
Top Products
Copying from the Bypass Tray
63
2
When Copying onto OHP
Transparencies or Thick Paper
To make copies onto OHP transpar-
encies or thick paper, you need to
specify the paper type.
Note
❒ Select [Thick Paper] if the paper
weight is more than 128g/m
2
, 34
lb.
A
Open the bypass tray, and adjust
the guides to the paper size.
Important
❒ If the guides are not flush with
the copy paper, a skew image or
paper misfeeds might occur.
B
Lightly insert the OHP transpar-
encies or thick paper face down
until the beeper sounds.
The k indicator on the display au-
tomatically goes on.
Important
❒ When you set an OHP transpar-
ency, make sure that its front
and back faces are properly po-
sitioned.
❒ To avoid paper misfeeds, fan
the paper before setting it in the
tray.
C
Press the {
{{
{#}
}}
} key.
D
Select [OHP Sheet] or [Thick Paper].
E
Press the [OK] key.
F
Set your originals and press the
{
{{
{Start}
}}
} key.
Important
❒ When copying onto OHP trans-
parencies, remove copied sheets
one by one.
G
When your copy job is finished,
press the {
{{
{Clear Modes}
}}
} key to
clear the settings.
AdonisC2_ENcopy122F_FM.book Page 63 Thursday, February 15, 2001 3:23 PM