Filter
Top Products
Copy Settings
40
3
Settings You Can Change with User Tools
This section is for the key operators in charge of this machine. You can change
or set the machine's default settings.
Note
❒ For how to enter the User Tools program, press the {Clear Modes/Energy Saver}
key, and then press the {Clear/Stop} key for more than 3 seconds.
• Fusing Temperature 1–Normal(+01): Selects the fusing temperature for plain
paper.
Note
❒ 0: Mode 1, 1: Mode 2, 2: Mode 3, 3: Mode 4, 4: Mode 5, 5: Mode 6, 6: Mode 7
❒ Default: 2
❒ For details about each mode, contact your service representative.
• Fusing Temperature 2–High (+02): Selects the fusing temperature for trans-
lucent paper.
Note
❒ 0: Mode 5, 1: Mode 6, 2: Mode 7, 3: Mode 8
❒ Default: 0
❒ For details about each mode, contact your service representative.
• Fusing Temperature 3–Low(+03): Selects the fusing temperature for translu-
cent film.
Note
❒ 0: Mode 2, 1: Mode 3, 2: Mode 4, 3: Mode 5
❒ Default: 1
❒ For details about each mode, contact your service representative.
• Count Up/Down(+04): The copy counter can be made to count up or count
down.
Note
❒ 0: Count up, 1: Count down