Filter
Top Products
WebSTAR DPR2320 and EPR2320 Gateway Cable Modems User’s Guide
46
Setup Advanced Settings – Options Page Description
The following table provides a description of the fields within the Setup Advanced
Settings – Options page.
If you make changes in the Setup Advanced Settings – Options page, click
Apply to apply and save your new IP address filter settings.
Field Name Description
WAN Blocking Checking this box prevents the gateway cable modem
from being visible to the WAN. For example, pings to the
WAN IP address are not returned
Ipsec PassThrough Checking this box allows applications that use IPSec (IP
Security) to pass through the firewall
PPTP PassThrough Checking this box allows applications that use Point to
Point Tunneling Protocol (PPTP) to pass through the
firewall
Remote Config
Management
Checking this box enables Remote Configuration
Management that allows the user or network operator to
view and/or modify the gateway set-up parameters from
a location on the WAN, as opposed to the LAN side of
the gateway. Access to the set-up parameters is
obtained by using the password to access the
WebWizard.
Enable this feature by checking the Remote Config
Management box on the Setup Advanced Settings –
Options page. To access your gateway from a remote
location, you must also know the WAN IP address of the
gateway. To find the WAN IP address, go to the
Network Configuration page under Basic Settings. You
will find the gateway’s WAN IP address list on this page.
Enter the WAN IP address of your gateway into the
address field of any Web browser using the following
format: http://xxx.xxx.xxx.xxx:8080
where
xxx.xxx.xxx.xxx represents the WAN IP address of your
gateway.
Be sure to follow the syntax exactly, and then click Go
or press Enter. Your gateway Web pages will appear on
the remote computer. You will still need to enter your
password to access the Setup pages of your gateway
If you choose to enable (check) this feature, be
sure to set up a user password to prevent unauthorized
access to your gateway settings.
Multicast Enable Checking this box allows multicasts to pass from the
WAN side through to the private network