Filter
Top Products
Medalist Pro 2160N, Rev. B 11
Configuring your computer
Before you format or partition your new drive, you must configure
your computer’s BIOS to show that no hard drives are installed.
1. Turn your computer on. As your computer starts up, watch the
screen for a message that describes how to run the system
setup program (also called BIOS or CMOS setup). This is
usually done by pressing a special key, such as
DELETE
,
ESC
or
F
1
, during startup. See your computer manual for details.
Press the appropriate key to run the System Setup program.
If you have no ATA drives in your computer, your BIOS should
be configured to show that no hard drives are installed.
2. Set the drive type in your System Setup program to
zero,
none
or
not installed
.
3. Save the settings and exit the System Setup program. Your
computer will automatically reboot.