Filter
Top Products
Medalist Pro 2160N, Rev. B 21
The system hangs in FDISK or fails to create or save the
partition record.
•
Check all cables.
•
Your DOS diskette may be corrupted. Try using a backup DOS
diskette.
•
Make the partitions smaller.
•
Change the interrupt jumper setting on the host adapter.
The system error message, “Drive not Ready,” appears.
•
Check all cable connections. Make sure pin 1 of the drive is
connected to pin 1 of the SCSI host adapter.
•
Make sure the power supply is adequate for system needs.
•
Reboot the computer and make sure the drive spins up.
The FDISK error message, “No Fixed Disk Present,”
appears.
•
Make sure the power supply is adequate for system needs.
•
Verify the drive-type values in the system setup program.
•
Check for I/O address conflicts.
•
If you have partitioned the drive into individual logical drives,
you may need to make the partitions smaller to access the full
drive capacity.
The DOS message “Disk Boot Failure,” “Non-System Disk”
or “No ROM Basic – SYSTEM HALTED” appears.
•
Reinstall the DOS system files using the DOS SYS utility.
•
Check all cables.
•
Use FDISK to verify that the primary partition is active.
•
Check for viruses.