Filter
Top Products
CONSTELLATION ES.3 SERIAL ATA PRODUCT MANUAL, REV. A 27
3.4 DRIVE MOUNTING
You can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-mounting holes. See
Figure 11 for drive mounting dimensions. Follow these important mounting precautions when mounting the drive:
• Allow a minimum clearance of 0.030 in (0.76mm) around the entire perimeter of the drive for cooling.
• Use only 6-32 UNC mounting screws.
• The screws should be inserted no more than 0.150 in (3.81mm) into the bottom or side mounting holes.
• Do not overtighten the mounting screws (maximum torque: 6 in-lb).
• Do not cover breather hole on top cover.
Breather Hole
Do Not
Cover
• Breather hole location - top cover