Filter
Top Products
Section 1. Introduction
9
Hardware Overview (continued)
Figure 1.2 Control Panel
q The Main Power Circuit Breakers provide over-current protection.
Figure 1.3 Circuit Breaker / Power Cable Entrance
q The Power Cable Entrance is the point where the cable connected to the power
source enters the machine. It connects the machine to the following power
sources:
• 228-240VAC, 50/60 Hz, single phase, 30 Amps.
Maximum Power Consumption: 6000 Watts
It is strongly recommended that the machine is fed from an “Earth Leakage”
protected electrical outlet – if in doubt, please contact Seal Graphics Technical
Services (listed at rear of manual) or consult a licensed electrician.
Main Power
Heaters
Engaged
Temperature
Controller
Speed
Controller
Main Power
Circuit Breakers
Power Cable
Entrance