Filter
Top Products
49
16 Adjusting the sensitivity (SEnSit)
Close talking distances, speakers with loud voices or loud music
passages may cause overmodulation in the transmission link,
resulting in distortion. If, on the other hand, the sensitivity is adjusted
too low, the transmission link will be undermodulated, which would
result in a signal with high background noise.
The sensitivity has to be adjusted so that the overmodulation
indication on your receiver only lights up during the loudest
passages. The following figures are a guide to the best settings:
Loud music/vocals: –30 / –20 dB
Presentations: –20 / –10 dB
Interviews: –10 / 0 dB
̈ Select the “SEnSit” menu by pressing the SET button until
“SEnSit” appears on the display; after a short pause the current
input sensitivity setting is displayed.
̈ With the ̆/̄ buttons you can now select a different setting. The
sensitivity can be adjusted in 10-dB steps from 0 to –30 dB. The
new setting starts flashing on the display and becomes effective
immediately.
̈ Press the SET button to return to the top menu level. The display
then switches back to the standard display.