Sharp AR-164 All in One Printer User Manual


 
35
SPECIAL FEATURES
1
Place the original on the original table and close the
platen cover.
The SPF can also be used for this feature.
2
Press the ERASE key to select the desired erase mode.
To select the EDGE + CENTER ERASE mode, press the ERASE key
until both the EDGE and CENTER indicators light up.
3
Check the copy paper size.
The bypass tray and any tray with non-standard size paper cannot be
used for this feature.
If an optional paper feed unit is installed, use the TRAY SELECT key
to select the desired paper size.
Erase
ERASE
This copier has an edge erase mode and a center erase mode.
Edge erase can be used to eliminate shadow lines around the edges of
copies caused when thick paper or a book is used as an original.
Center erase can be used to eliminate the shadow produced by the
bindings of bound documents.
Edge + center erase can be used to eliminate shadow lines around the
edges of copies and to eliminate the shadow at the center of copies.
The erase width can be set from 0" to 1" in five steps using user program
No. 16. See page 46.
This feature cannot be used with the 2 in 1 or 4 in 1 feature.
A B
A B
A
A
A B
A B
Center erase
Edge + Center erase
Edge erase