Filter
Top Products
58
GENERAL INFORMATION
Problem Solution
Copier trouble?
COPIER TROUBLE?
COPY/FAX key
The COPY/FAX key is used to switch
between the FAX and COPY modes.
For details, see the MULTI ACCESS
manual.
●
Original table or document feeder
cover dirty?
●
Original smudged or blotchy?
●
Is the indicator on?
●
Is the indicator on?
●
Is the COPY indicator off?
●
Is copying, printing or facsimile
printing being performed?
●
Is the POWER SAVE indicator
blinking?
●
Is only the POWER SAVE
indicator on? (when an optional
printer or facsimile expansion kit is
installed)
●
Is the COPY indicator off?
●
Is steadily lit in the copy
quantity display?
●
Is the indicator on?
Clean regularly. See page 55.
Use a clean original.
Developer is required. Contact your SHARP
service center as soon as possible. See page 45.
Maintenance is required. Contact your SHARP
service center as soon as possible. See page 45.
Use the COPY/FAX key to select the COPY
mode. See Note below.
Set the paper size after copying, printing or
facsimile printing is complete.
Wait until warm-up is complete.
Warm-up time is approximately 35 seconds.
The copier is in the auto power shut-off mode.
Press the START key. See page 53, POWER
SAVE MODES.
Use the COPY/FAX key to select the COPY
mode. See Note below.
The copier is in the auditing mode.
Enter your account number using the numeric
keys. See page 13.
Copy paper is needed. See page 10, LOADING
COPY PAPER.
Copies are smudged
or dirty.
Power is on but copying
is not possible.
Paper size for a paper tray
cannot be set.