Sharp ER-A347A Cash Register User Manual


  Open as PDF
of 115
 
13
3
 PriortoMakingEntries
PreparationsforEntries
■
Receiptandjournalpaperrolls
If the paper roll (receipt or journal) is not set in the register or it is getting low, install a new one according to
section “Replacing the Paper Roll” under “Operator Maintenance.”
■
ReceiptON/OFFfunction
You can disable receipt printing in the REG mode to save paper using the receipt function.
Press the
H
key. Select “2 RECEIPT SW” and press the
A
key. Select “OFF” to disable receipt
printing and press the
A
key. When the function is in the OFF status, the receipt off indicator “R” is
highlighted.
NOTE
Your register will print reports regardless of the receipt state. This means that the receipt roll
must be installed even when the receipt state is “OFF”.
■
Clerkassignment
Prior to any item entries, a clerk must enter his/her clerk codes into the register.
To sign on:
Clerk code Secret code
(In case secret code is 0000)
L A
To sign off:
L
ErrorWarning
In the following examples, your register will go into an error state accompanied with a warning beep and the
error message on the display. Clear the error state by pressing the
l
key and then take the proper action
to remedy the problem.
• When you exceed a 32-digit number (entry limit overow):
Cancel the entry and reenter a correct number.
• When you make an error in key operation:
Clear the error and try the entry again.
• When you make an entry beyond a programmed amount entry limit:
Check to see if the entered amount is correct. If it is correct, it can be rung up in the MGR mode.
Contact your manager.
• When an including-tax subtotal exceeds eight digits:
Clear the error message by pressing the
l
key and then press a media key to nalize the
transaction.
 previous next