Filter
Top Products
118
Recording paper specifications
Be sure to use paper rolls specified by SHARP.
The use of any other paper rolls than specified could cause paper jamming, resulting in register malfunction.
Paper specification
Paper width: 44.5 ± 0.5 mm
Max. outside diameter: 80 mm
Weight: 52.3 — 64.0 g/m
2
Quality: bond paper
Paper tube: 18 mm
• Be sure to set paper roll(s) prior to using your machine, otherwise it may cause a malfunction.
Install the paper roll in the printer. Be careful then to set the roll and cut the paper end correctly.
(How to set the paper roll) (How to cut the paper end)
To release the paper, press the paper release lever down. It is
also used for removing a paper jam. The method for removing a
paper jam is described in “Removing a paper jam” later in this
section.
Installing the paper roll
Installing the receipt paper roll
1.
Turn the mode switch to the “REG” position with the AC cord
connected.
2.
Remove the printer cover.
3.
Set the paper roll correctly and drop it into the printer.
4.
Press the receipt paper release lever down and insert the
paper end into the paper chute of the printer.
5.
Pull the paper end that has come out of the printer, holding
down the lever.
6.
Advance the paper by a required length by pressing the receipt
paper feed key.
7.
Replace the printer cover.
Receipt side Journal side
Paper replease lever
Installing and removing the paper roll
4
To the printer
Incorrect
To the printer
Correct
Correct Incorrect