Filter
Top Products
61
Selection of X1/Z1 and X2/Z2 reports
to be printed in the stacked report sequence
Your register is equipped with the stacked report printing function that enables multiple X/Z reports to be printed
in sequence with only a single request, up to maximum of 13 reports*. This function continuously prints a
maximum of 13 kinds of reports with a single operation.
*: Maximum 70 steps are programmable. “1 step” means the memory size used for one no-range type job no.
The range type job no. needs “8 steps”.
Job code numbers to be used are as follows.
*1 *2
*3: Both range setting and full setting are allowed.
When Z of stacked report is initiated, X only reports will be skipped.
2620
. ≈
10
:
13
:
;
PrintKey operation
Example
Note
00
10
13
20
27
29
30
31
32
40
50
60
70
Job no. Report Available mode Range parameter
General report
Full department report X1/X2 mode only
Full department group report X1/X2 mode only
PLU report *3 Start PLU code/end PLU code (1 through 999999)
PLU zero sales report X1/X2 mode only
PLU price category report X1/X2 mode only *3 Start price amount/end price amount
Transaction report X1/X2 mode only
Total in drawer report X1/X2 mode only
Commission sales report
Full clerk report
Full cashier report
Hourly sales information Range report is available *3 Start time/end time (0 through 2330)
only in the X1 mode.
Daily net report X1/X2 mode only
2620
.
≈
≈ ≈
:
;
Job no.
Start range
parameter
For full reporting (non-range report)
To cancel the stacked report sequence
To repeat*
*1
*2
For individual reporting
End range
parameter
*2
Procedure
2620
PGM 2