Sharp XG-C60X Projector User Manual


 
Easy to Use Functions
-57
Displaying Dual Pictures (Pict in Pict)
Picture in Picture function allows you to display two pictures on the same screen. You can
display the image input from INPUT 3 or 4 as an inset picture overlapping the main picture
from INPUT 1 or 2.
Displaying the Inset Picture
1 Press .
2 Press or on the remote
control or
on the projector
to switch the image in the in-
set picture .
3 Press
''
''
',
""
""
",
\\
\\
\ and
||
||
| to set the
position of the inset picture.
Press to stop the frame from mov-
ing or to make the frame disappear.
4 Press to move the inset pic-
ture.
The inset picture will be moved to the
inset picture frame.
Note
The inset picture can only be displayed
with composite video (NTSC/PAL/
SECAM) or S-Video signal.
The Freeze function works only with the
inset picture, when the Pict in Pict mode
is in operation.
When the signal entered into INPUT 1 or 2
is as follows, Pict in Pict does not work:
With a resolution that exceeds SXGA.
When the input signal is 480
I, 480P,
540P, 580
I, 580P, 720P, 1035I or 1080I.
When the input signal has changed to
the Interlace mode using RGB signals.
When the picture display mode is set to
DOT BY DOT.
When no signals are sent to INPUT 1 or
2, or when the resolution or refresh rate
(vertical frequency) is changed.
', ", \, | buttons
PinP button
INPUT 3/4 buttons
UNDO button
ENTER button
XG-C60X_E_PDF_p51_59.p65 03.8.28, 2:10 PM57