7-34
SYSTEM SETTINGS
Contents
* When a saddle stitch finisher is installed.
Network Settings
X Erase Width Adjustment
7-69Edge Clearance Width 10 mm
Centre Clearance Width 10 mm
X Card Shot Settings
7-69Original Size X: 86 mm, Y: 54 mm
Fit to Page Disabled
X Automatic Saddle Stitch* Enabled 7-69
X Initial Tab Copy Setting 10 mm 7-69
X Disabling Deletion of Job Programs Disabled 7-70
X Disabling of Bypass-Tray in Duplex Copy Disabled 7-70
X Disabling of Auto Paper Selection Disabled 7-70
X Auto Selection Setting of Tray that is Supplied the Paper Disabled 7-70
X B/W 600dpi x 600dpi Scanning Mode for Document Feeder Disabled 7-70
X B/W Quick Scan from Document Glass Enabled 7-70
● Colour Adjustments 7-71
X Initial Colour Balance Setting Factory default state 7-71
X Auto Colour Calibration – 7-71
Item Factory default setting Page
■ Network Settings
7-72
● IPv4 Settings DHCP 7-72
● IPv6 Settings Disabled 7-72
● Enable TCP/IP Enabled 7-72
● Enable NetWare Enabled 7-72
● Enable EtherTalk Enabled 7-72
● Enable NetBEUI Enabled 7-72
● Reset the NIC – 7-72
● Ping Command – 7-72
Item Factory default setting Page